The Replacement Parts Thread

[Nick MC]

IMG_2333.jpg (2.81 MiB) Viewed 1484 times

Finally got this delivered after a few weeks. It was back ordered with no ETA. Rear trunk latch. This was the old one. Had an issue with the servo motor not moving the lock switch. Tried lubing it cleaning it , went through 2 junk yard parts before I gave in and bought new OEM.

[mugen power]

If i'm not mistaken I believe there is a part from an odyssey door actuator that you can swap the motor and other internals out of to fix the latch

[Stin1]

Adler which is sold at advance auto is made in Japan. The nissin is present on the hydraulic products.

[thanh]

If i'm not mistaken I believe there is a part from an odyssey door actuator that you can swap the motor and other internals out of to fix the latch

hrmmm... I remember seeing a 3d printed fix for it.

https://www.thingiverse.com/thing:15386

I printed it but haven't had a chance to try....

[aw614]

Oh yeah I recall a member here made the 3d printed fix. Oddly enough with my trunk that piece wasn't broken and years later I am still have weird issues opening my trunk without the key even with a new actuator.

Still never liked the 98-01 trunk vs what was on the 94-97

[coolhandluke]

Oh yeah I recall a member here made the 3d printed fix. Oddly enough with my trunk that piece wasn't broken and years later I am still have weird issues opening my trunk without the key even with a new actuator.

Still never liked the 98-01 trunk vs what was on the 94-97

I always wanted to convert my '98 to the '94-97 trunk pull....it's on the extended project list.

[Nick MC]

Oh yeah I recall a member here made the 3d printed fix. Oddly enough with my trunk that piece wasn't broken and years later I am still have weird issues opening my trunk without the key even with a new actuator.

Still never liked the 98-01 trunk vs what was on the 94-97

I always wanted to convert my '98 to the '94-97 trunk pull....it's on the extended project list.

The donor R had a manual trunk release, sans the cable and lever. I almost swapped all that over but wanted to keep functionality with the alarm and keyless when it’s installed.

[AndyD]

I received my order that included a new non-CF center vent trim. I tried to order it a few months ago and was removed from my order due to NLA. I saw it still listed on the website so I figured it was worth a shot again. Well, it arrived!

[Klasse]

Not sure if this is news but 53010-ST0-000 rack ends appear to be discontinued now. Also the front upper control arms.

Anyone have a go to for quality rack ends? Or ideally somewhere that still has OEM...

[dcharles85]

I know moog has the tie rod sets available and HardRace makes an OE set but seems to be sold out. As far as the front upper control arms this site is still showing available.
https://www.acurapartswarehouse.com 51450-ST7-020 / 51460-ST7-020