Type R Club of America

I bought the right size brake dust shields for the front suspension. Found a set of JDM ITR ones off eBay.

Today I got the new OEM hubs pressed in on front knuckles, so they are all set to go. They have new OEM wheel bearings and Spoon ball joints. And then took off the passenger front wheel liner to clean it up and put on some black restore stuff. Also cleaned up the wheel well. This is about the best I can do.

Starting to put the front passenger suspension back together. Here are the lower arm pieces, with Mugen compliance bushing, hard race sway bar link, and zinc plated bolts/nuts. Looking good. Very excited to see it all installed with Ohlins. Hopefully will have this section done this wknd.

Ohlins

I got some OEM license plate hole plugs (I think they're for S2000). Look pretty good.

I got Mugen bushings pressed in to the front passenger control arm. Pretty happy about that.

Those Ohlins look too nice to use! Loving the progress.