Since I plan to use a phone or small tablet to provide an extended digital dash I'm trying a new "Integra" specific model (ProClipUSA, actually from Sweden?). I didn't see much feedback out there so wanted to share my impressions and some test shots.
I ordered the Integra mount and a the most basic phone holder (for my iPhone 8 w/ slim case, there are a lot of options, some include power but get
![Broke :moneyburn:](./images/smilies/moneyburn.gif)
![Broke :moneyburn:](./images/smilies/moneyburn.gif)
I'll be pulling data from my RaceCapture unit but for anyone using digital dash apps to capture acceleration data from a phone's sensors this mount should help with accuracy of the captured data over other mounts that allow more movement. The holder ball joint is larger (so a bit more stable, but more limited in range) than most other mounts I've seen and stiffness can be adjusted via Philips screw. The lower adhesive pad may still allow some movement, but it should be pretty marginal and you could always use a touch of hot glue if the adhesive pad allows too much wiggle for you.
Overall it's likely the best holder I've tried. Pretty well thought through and holds the phone solid in the car.
Photos are with the holder pretty low on the mount, I'll probably move it up toward the top so the phone is closer in my line of sight, that should also add some more clearance with an extended shifter.
(On loose ITR console)
![Image](https://i.imgur.com/Adbb2MKh.jpg)
![Image](https://i.imgur.com/yl7248rh.jpg)
(Staged in my old LS)
![Image](https://i.imgur.com/85PwLaoh.jpg)
![Image](https://i.imgur.com/nfMEmFsh.jpg)